Electronic Brick - Big Button

00002244
Electronic Brick Big Button Arduino Dezvoltare
4,44 RON
cu TVA 1-2
2 bucăţi în stoc

 

Livrare rapida

 

Transport gratuit la comenzi peste 300 lei in aria de acoperire

 

Perioada de retur 30 zile

euplatesc.ro

Modul buton, compatibil cu platformele de dezvoltare Arduino (sau clone).

EB_Button.jpg

  Electronic Brick

By using electronic bricks, you may connect Arduino compatible boards easily with various digital, analog and I2C/Uart interfaces. These the breadboard-less firm connection are prepared to extensive modules like poteniometers, sensors, relays, servos...even buttons, just plug and play. 

Each terminal module has buckled port with VCC, GND and Output, which has corresponding port on the sensing board, with a plain 2.54mm dual-female cable you may start playing already. Buckled brick cables are like cement for bricks, make the connections easier, secure and more professional looking.

EB

  Overview

A simple obvious button that fits finger pad rather than nails.

When you connect the + and - pins to power supply, you can use this to get the digital signal output from S pin. It's high level when the button releases, and it will output low level when the button is pressed.

 

 Programming

1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
int Button=2;
int LED=13;
void setup()
{
 pinMode(LED, OUTPUT);
 pinMode(Button, INPUT);
  
}
 
void loop()
{
  
if (digitalRead(Button)==HIGH)
 {
 digitalWrite(LED, HIGH);
  
 }
  
 if (digitalRead(Button)==LOW)
 {
 digitalWrite(LED, LOW);
 }
 
}
 

Specification

Brick Type:  Button and Switch
Brick Interface:  3PIN
Brick Power Supply:  5V
Board Size:  37 × 21 × 1.6mm
Weight:  20.00g

 
EB2.JPG
00002244

Referinte specifice

close
Wishlist